The short answer
A strong ammonia smell in cloth diapers usually means they aren’t getting fully clean. Urine residue and bacteria are staying in the fabric between washes. Bacteria break down the urea in that residue into ammonia, and the smell becomes sharp and obvious the moment the diaper gets wet again.
The most common causes are too little detergent, a drum that’s too empty or too full, a main wash that’s too short or too cool, hard water, and waiting too long between washes. Fixing the routine usually solves it. A one-time sanitizing wash can reset diapers that are already smelly.
How ammonia forms in cloth diapers
Urine contains urea. When bacteria break urea down, it releases ammonia. A little of this happens in any wet diaper, which is why a pail of dirty diapers smells. In clean diapers, though, it shouldn’t happen at all.
If a freshly washed diaper smells strongly of ammonia soon after your baby wets it, there’s leftover residue and bacteria in the fabric from previous uses. Each new wetting gives them more to work with, so the problem tends to get worse over time.
When does it smell? Using timing to diagnose
| When you notice it | What it often points to |
|---|---|
| Clean diapers smell faintly of urine straight out of the wash | Underwashing or a routine that isn’t removing enough |
| Smells fine out of the wash, sharp ammonia within minutes of wetting | Buildup of residue and bacteria. Fix the routine and possibly sanitize |
| Pail smells overwhelming before wash day | Too long between washes, or a sealed pail trapping moisture |
| Only overnight diapers smell | Concentrated urine and long wear. Rinse before pailing |
| Stiff, dingy inserts plus smell | Possible hard water mineral buildup |
Common causes
Not enough detergent
This is the most common cause. Some older cloth diaper advice recommended very small amounts of detergent to avoid “buildup.” In practice, underdosing leaves residue behind. A common starting point is the amount your detergent recommends for a heavily soiled load, adjusted for your water hardness.
Load too small or too big
Diapers get clean by rubbing against each other. A drum with a few diapers sloshing around doesn’t scrub well. An overstuffed one can’t move. In front loaders, many people aim for about two-thirds to three-quarters full after the prewash, adding small items like baby clothes if needed.
Main wash too short or too cool
A quick cycle or a cold main wash may not be enough for diapers. Use your machine’s longest, most thorough cycle at the warmest temperature your diapers’ care labels allow. A short prewash before the main wash removes most of the mess first. Our complete cloth diaper wash routine covers the setup.
Hard water
Minerals in hard water interfere with detergent and can build up in the fabric along with residue. If you have hard water and aren’t adjusting for it, that may be the cause. See washing cloth diapers in hard water.
Too long between washes
The longer dirty diapers sit, the more ammonia forms, and the harder it is to wash out. Most guidance suggests washing every two to three days. A tightly sealed pail can make it worse by trapping humidity. Our guide to diaper pails for cloth diapers explains why some airflow helps.
Fabric softener, creams and residue
Fabric softener, dryer sheets and non-cloth-safe diaper creams can coat fibers. That makes them harder to clean and can trap residue. Use a liner when you need cream, and skip softener entirely.
Overnight and toddler diapers
As babies get older, their urine becomes more concentrated and overnight diapers are worn longer. These diapers often smell the strongest. Rinsing heavy overnight diapers before putting them in the pail can help, and so can washing them in every load rather than letting them sit.
Microfiber inserts can also be harder to get fully clean than some natural fibers, according to many cloth diaper users. If only your microfiber smells, that’s a clue.
A step-by-step fix
- Check your water hardness with a test strip or your water supplier’s report.
- Reset the diapers. If they already smell, a one-time sanitizing wash or soak can kill the bacteria causing the smell. See how to bleach cloth diapers safely and check your diaper brand’s guidance first.
- If you have hard water and stiff inserts, consider a mineral strip as a separate step. See how to strip cloth diapers with RLR.
- Fix the routine going forward:
- Short prewash with some detergent.
- Long, warm-to-hot main wash.
- Full detergent dose for a heavily soiled load.
- Properly filled drum.
- Water softener if your water is hard.
- Wash every two to three days.
- Give it a few weeks. If the smell returns, adjust one thing at a time, usually detergent amount first.
A reset without a routine change usually only buys a few weeks before the smell comes back.
Ammonia vs barnyard smell
Cloth diaper users often describe two different smells:
- Ammonia: sharp, eye-watering, like strong cleaning products. Usually urine residue and bacteria.
- “Barnyard” or musty: a duller, earthy funk. Often linked to poop residue, hard water minerals, or diapers not drying fully.
Both usually point back to the wash routine, but barnyard smells make hard water and drying worth looking at.
Can ammonia hurt my baby’s skin?
Strong ammonia in diapers can irritate a baby’s skin. Some parents describe red, irritated patches that look like a burn, especially after overnight diapers. If you see this, check with your pediatrician, since diaper rashes have many possible causes, including yeast, and some need treatment. Fixing the wash routine helps prevent ammonia from causing problems in the first place.
What not to do
- Don’t mask the smell with scented detergents, essential oils or sprays. The residue and bacteria are still there.
- Don’t cut the detergent to “avoid buildup.” Underwashing is the more likely problem.
- Don’t add fabric softener to “freshen” diapers.
- Don’t mix chemicals. Never combine bleach with ammonia-containing products, vinegar or other cleaners, and never add bleach to a load that already contains another treatment.